Freesco, NND, CDN, EOS
http://forum.freesco.pl/

IPSec pomoc przy konfiguracji
http://forum.freesco.pl/viewtopic.php?f=39&t=18670
Strona 1 z 1

Autor:  wanter [ środa, 8 lutego 2012, 10:19 ]
Tytuł:  IPSec pomoc przy konfiguracji

Witam, czy ktoś mógłby pomóc mi skonfigurować VPNa po IPSecu. Dysponuję wydrukiem konfiguracji "odbicia lustrzanego" od strony, z którą muszę się połączyć.

: [/] [] ()
The mirror configuration should only be used as a guide when configuring the peer.

The following configuration MUST NOT be directly applied to the peer device.

crypto isakmp policy 2

authentication pre-share

encr 3des

hash sha

group 2

lifetime 86400

exit

crypto isakmp policy 1

authentication pre-share

encr aes 256

hash sha

group 5

lifetime 86400

exit

crypto isakmp key klucz_polaczenia address adres_ip_serwera

crypto ipsec transform-set SFERA esp-sha-hmac esp-aes 256

mode tunnel

exit

ip access-list extended SDM_2

remark SDM_ACL Category=4

remark IPSec Rule

permit ip 192.168.1.120 0.0.0.7 host 192.168.0.60

exit

crypto map SDM_CMAP_1 8 ipsec-isakmp

description Apply the crypto map on the peer router's interface having IP address adres_ip_zewnetrszny that connects to this router.

set transform-set SFERA

set peer adres_ip_serwera

match address SDM_2

exit


Czy ktoś jest w stanie przełożyć to na ustawienia IPSeca? Z góry dziękuję za pomoc.

Strona 1 z 1 Strefa czasowa UTC+2godz.
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/